Category: Expert tutorials

With the release of EcoButler version 1.5, two new conditions related to the sun were included. On this page you will learn about the configuration and correct use of these conditions. The new conditions are available in EcoButlers registered with licenses from Gold upwards. Solar azimuth The Solar azimuth is direction,…

This article describes our new methods to easily join KNX group addresses – i.e. assigning read and write addresses to each other – in the ayControl Editor. While this can be very time consuming if done manually, our automatic methods can help you to join hundreds of addresses within minutes.…

How to set the heating/cooling mode of a KNX room thermostat This article describes on how to integrate the KNX room controllers HVAC mode in the ayControl KNX visualisation for iPad, iPhone and Android. Similar to temperature control, there are different ways to set the HVAC-mode. In general we have…

Here you learn on how to control and visualise standard KNX room thermostats with ayControl on iPad, iPhone or Android devices. Note: There are different modes to interact with KNX room temperature controllers when it comes to setting the desired temperature.Most of them are supporting setting the desired temperature via…

Did you know that you can trigger complex sequences and scenes by pressing a wall-mounted push button with ayControl and EcoButler? And did you know that you can use IF/THEN logic in EcoButler rules? Advantages Implement large scenes, e.g. check-in/check-out functions, where users can themselves change the executed actions and…